39
©2017 Guangzhou ZHIYUAN Electronics
Date: 2017/08/04
User Manual
V1.02
C
Guangzhou ZHIYUAN Electronics Co., Ltd.
High performance 2-channel WiFi-to-CAN Converter
CANWiFi-200T User Manual
Type
Name
Default Value
Description
CAN
configuration
End address 1
192.168.0.55
It is only valid in the TCP Client and UDP mode. This
item is used to define the end IP of IP address
segment. If there is only 1 destination address, the
end address is equal to the start address.
Note: If an IP address is filled in this item to enable
multiple network devices to communicate with the
CANWiFi-200T device simultaneously, the first three
bytes of the IP address segment must meet the limit of
subnet mask 1, and the fourth byte of the end address
should be greater than or equal to the fourth byte of
the start IP address.
Destination port 2-6
0
This item can be filled in 1~65535. The function of
them is same as the destination port 1. Users should
set the number of TCP connections before enable
them.
Subnet mask 2-6
0.0.0.0
They are used for mask. Users should set the number
of TCP connections before enable them.
Start address 2-6
0.0.0.0
The function of them is same as the start address 1.
Users should set the number of TCP connections
before enable them.
End address 2-6
0.0.0.0
The function of them is same as the end address 1.
Users should set the number of TCP connections
before enable them.
The default value of each CAN1 parameter is exactly the same, except for operating
port, destination port, destination IP. The meaning of these parameters is the same as
the corresponding CAN0 parameter, so they are not listed in the above table.
6.4 Save and restore settings
To facilitate users to modify the configuration information of the CANWiFi-200T
device in batches, the ZNetCom software provides configuration information
import/export function. The Import/Export function button is placed on the property
bar, as shown in Figure 6-11.
Figure 6-11: Import/export device configuration information
6.4.1 Save settings
Click the
“Export” button, and then select the directory and input the file name in the
