Zline RBIV-30, Installation Manual

CABINETS

Make sure that the cabinets where you will install the appliance has been safely mounted in 
your kitchen. Your cabinets must be connected to the floor and the wall properly and with 
suitable connections.

For the best installation, clearances between the cabinets and the product must be in 
compliance with the values specified in the installation instructions.

Side walls must be free of clearances and their surfaces must be flat. 

Minimum thickness of 

the side walls is 5/8" (16 mm).

Note: Minimum thickness of the doors to be attached to the product must be ¾" (19 mm).

ATTENTION

Failure to follow these instructions may result in death, fire or electric 
shock. Connecting the grounding conductor of the equipment to an 
improper place may lead to electric shock. Please have the grounding 
checked by a qualified electrician or service technician if you have any 
doubt about the proper grounding of the product.

Installation, repair and other procedures performed by unqualified 
persons may cause danger. Before installing the appliance, make sure 
that the voltage, load and circuit current parameters on the data plate 
are in compliance with the power mains in your house.

The appliance is provided with a NEMA 5-15 P plug and a 3-pin 
power cable which is in the UL list and ready to be connected to a 120 
V, 60 Hz power supply. Fuse is 15 A. The appliance must be connected 
to an electrical outlet receptacle. The plug must be installed only by a 
licensed electrician.

If the electrical wiring or the electric power supply of the house needs 
alteration, the necessary procedures must be performed by a qualified 
electrician.

ATTENTION

Do not install your refrigerator:

•  In open areas
•  In environments where water is dripping
•  In environments where temperature is lower than 61° F (16°C)

VENTILATION

Vent panels where the air enters and exits the unit must not be blocked or obstructed. 
In addition, you must periodically clean the dust and dirt that accumulate on these 
holes in time.

E

LECTRICAL CONNECTION

•  Never use an extension cable.
•  The  electrical  outlet  receptacle  must  be  grounded  and  checked  by  an  authorized 

person.

•  Location of the electrical wiring must comply with the dimensions specified in the 

manual.

Please wait for 3-6 hour before energizing the product to protect it 
against possible damages. This way, the refrigerant and the lubricants in 
the system get balanced.

WARNING

WATER CONNECTION:

•  Pressure of the mains water must be in compliance with the values specified in 

the manual.

•  Location of the water system must comply with the dimensions specified in the manual.

CAUTION

RISK OF ELECTRIC SHOCK

Electrical grounding is necessary. This appliance is equipped with a 
three-pin plug to protect you against possible electric shocks.
•  Do not remove the round grounding terminal from the plug.
•  Do not use two-pin grounding adapters.
•  Do not use extension cables to energize the product.

ATTENTION

Do not connect the grounding cable to the gas pipe. Please have the 
grounding checked by a qualified electrician if you are not sure about 
the grounding of the product. Do not install a fuse on the neutral line or 
grounding circuit.

i

Bypass is recommended for the water filtering system if a reverse 
osmosis system is used.

INFO

7

Pr

eparing th

e R

efriger

ator Enclosur

e

8

Electrical Connection

BEFORE INSTALLATION

BEFORE INSTALLATION