12
Rever
sing th
e Door Swing
INSTALLATION
REVERSING THE DOOR SWING
This appliance has the capability of the doors opening from either the left or right side. The
unit is delivered to you with the doors opening from the left side (Figure 1). Should you desire
to reverse the opening direction (Figure 2), follow the instructions below.
NOTE:
A second
person is recommended with this task due to the weight of the door.
Figure 1
Figure 2
Make sure the appliance is fully disconnected from power before performing
this task to avoid risk of electric shock.
WARNING
1. With the door open, use a drill or screwdriver to remove the 4 screws at the top and
bottom of the left side of the appliance cabinet face. Save the screws to reinstall once
the door reversal is complete.
2. Loosen the outer top and bottom screws on the right-side hinges. Do not fully remove
these screws to avoid the door falling and creating risk for injury.
3. Next, completely remove the inner top and bottom screws on the right-side hinges.
4. Initially secure the 2 removed screws about 3 turns into the left-side outer top and bottom
screw locations where the screws were removed in step 1.
5. Carefully slide the door from the 2 screw keyholes on the right-side hinges that were not
fully removed in step 2 and lift the door off the hinges.
6. Rotate the door 180° and slide the hinges on the 2 partially installed left-side screws
from step 4.
7. Remove the 2 screws loosened in step 2 from the right-side hinges and install them in the
open inner holes in the left-side hinge location. Tighten all screws.
8. Close the door and check for proper alignment. If needed, loosen the 4 screws enough
to slide the door as needed fine tune the alignment, then re-tighten all 4 screws.
9. Re-secure the 4 screws removed in step into the 4 open holes on the right side.
