15
Handle Installation
INSTALLATION
HANDLE INSTALLATION
Prior to installing a custom integrated panel around the glass door on RWDPO-24 and
RBSPO-24 models, handle(s) need to be affixed to the panel first. If you wish to install
a ZLINE Autograph Edition handle onto your custom panel, reference the measurements
displayed in the diagrams below regarding where to affix mounting studs
.
22 1/2
" (5
72 mm)
30
" (7
62 mm)
2 3/4
" (7
0 mm)
22 1/2
" (5
72 mm)
1 3/8
" (3
5 mm)
23 5/8" (600 mm)
3/4"
(20 mm)
Ø
1/2
" (1
2 mm)
Ø
1/4
" (6 mm)
1/4
"
1/3
"
(6
9 mm)
2 3/4" (70 mm)
DOOR HINGE TIGHTENING
The appliance’s door hinges may loosen over time, which is normal with regular use. Use the
provided Allen key to loosen or tighten screws securing the hinges to the door as necessary,
as outlined in the image below for RWDPO-24 and RBSPO-24 models. For RBSO-GS-24,
RWDO-GS-24, and RBSO-ST-24 models, hinge screws are located behind the rubber
door seal. You can easily remove the upper corners of the seal by hand to access the screws.
