p. 46/61
Figure 5.10.
Side view of the burner’s main module with detached grate
;
NOTE
: the grate of the burner should be taken out of the burner’s head after the
burner has been cooled down to safe temperature levels, in order to be cleaned
thoroughly. It is highly recommended to use self protecting means and to use
tool (for example pincers or any appropriate tool) in order to handle the grate
safely.
At the grate cleaning process, it is necessary to pay attention to clean thoroughly
the holes, which conduct the air though the grate, which will allow efficient
combustion process and optimal air cooling of the grate.
After thorough cleaning of the ash residue out of the burner’s grate, as well as
other unburned fuel particles and/or slagging material, the grate should be
carefully installed back on its initial position. The grate’s installation is made in
two steps : first :
incline the grate in order to direct its extension below the
inclined grate of the burner’s main module
, second :
slide the grate until the gap
between the grate and the inclined detail is diminished
;
Combustion head of
the burner’s main
module
Grate of the burner
Inclined grate of the
burner’s main module
