Pelletherm V.2 M01 39
„TRANS.:10kW
„ – indicates that the boiler is in an intermediate phase for
stabilization the combustion process, with thermal power of 10kW.
After going through this transient mode, the boiler goes into operation mode, as shown in
Figure 6.9.
Figure 6.9. The display of the boiler containing information about the extent of the thermal
power at peak thermal power mode.
„COMBUST 5 – 100kW” –
shows the degree of boiler thermal power (here
5th extent at which the thermal power of the boiler is 100 kW);
„78
о
”
- shows the water temperature,
o
C;
“FC: 98%” –
shows the intensity of the illumination of the photosensor, %.
6.2.11. USER MENUS FROM THE BOILER CONTROLLER.
By pressing and holding the "S" button is entering in the boiler menus. Exiting the selected
sub-menu is done by pressing "ESC".
Figure 6.10. Pressing the "S" button allows selection of a submenu of the boiler controller.
S
_
+
ESC
COMBUST 5 100kW
78
o
FC: 98%
S
_
+
ESC
COMBUST 5 100kW
78
o
FC: 98%