First-time Setup
3.9
Mounting the Camera
IMPORTANT:
Please complete the instructions for "Connecting the cameras to
the NVR" prior to mounting your cameras.
The following steps provide instructions to mount the camera on a drywall.
You will need:
1) IP camera
2) Mounting bracket (provided)
3) 3 screws with 3 anchor screws (provided)
4) Power drill (not provided)
1. Choose a location.
Find a suitable location to mount your IP camera.
2. Mark screw locations.
Using a pencil and the holes in the mounting bracket
as a guide, mark three holes against the wall where you wish to mount the
camera.
3. Drill holes.
With a drill bit slightly smaller than the green plastic anchor screw,
drill a 1" deep hole in each of the three marked locations.
4. Insert anchor screws.
Place the anchor with the closed end evenly into the
hole. Gently tap the open end until the anchor is almost flush with the wall.
5. Attach the camera to the mounting bracket.
Fasten your camera to the
mounting bracket using either the hole found on the top or bottom of the
camera. Rotate until the camera is securely attached to the mounting bracket.
6. Mount the camera to the wall.
Align your mounting bracket with the
anchors and slowly screw the bracket onto the wall with the 3 screws provided.
7. Adjust the camera position.
To adjust the camera position, loosen the nob
on the bracket by turning it counterclockwise and adjust the camera accordingly.
When the desired camera position is achieved, tighten the nob by turning it
clockwise.
Summary of Contents for ZP-NE14-S
Page 1: ...1...
Page 2: ...2...
Page 14: ...Product Introduction 2 7 Front Panel Rear Panel...
Page 15: ...Product Introduction 2 8 Mouse Remote Control...