VPLCE532E Vision Motion Controller User Manual V1.5
Item
High-Speed Input (IN0-3)
Low-Speed Input (IN4-23)
Input mode
NPN leakage type, the input is triggered when there is low-
electric level
Frequency
<100kHz
<5kHz
Impedance
3.3K
Ω
4.7K
Ω
Voltage level
DC24V
DC24V
The voltage to open
<15V
<14.5V
The voltage to close
>15.1V
>14.7V
Minimal current
-2.3mA (negative)
-1.8mA (negative)
Max current
-7.5mA (negative)
-6mA (negative)
Isolation mode
optoelectronic isolation
Note: the above parameters are standard values when the voltage of controller power
supply (E+24V port) is 24V.
→
Wiring Reference
→
Wiring Note:
⚫
The wiring principle of high-speed digital input IN (0-3) and low-speed digital input
IN (4-23) is shown in the figure above. The external signal source can be an
optocoupler, a key switch or a sensor, etc., all can be connected as long as the
requirements on output of electric level can be achieved.
⚫
For the public end, please connect the "EGND" port on the IO power supply to the
"COM" terminal of the external input device. If the signal area of power supply of the
external device and the power supply of the controller are in the same power supply
Summary of Contents for VPLC532E
Page 1: ......
Page 39: ...VPLCE532E Vision Motion Controller User Manual V1 5...