ZMC006CE Motion Controller User Manual V1.5
Isolation mode
optoelectronic isolation
Note: the above parameters are standard values when the voltage of controller
power supply (E+24V port) is 24V.
→
Wiring Reference
→
Wiring Note:
⚫
The wiring principle of digital input IN (0-23) is shown in the figure above. The
external signal source can be an optocoupler, a key switch or a sensor, etc., all can
be connected as long as the requirements on output of electric level can be achieved.
⚫
For the public end, please connect the "EGND" port on the power supply to the "COM"
terminal of the external input device. If the signal area power supply of the external
device and the power supply of the controller are in the same power supply system,
this connection also can be omitted.
3.4.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please select ETHERNET or RS232 or RS485 to connect to
ZDevelop.
(3)
State values of relative input ports
can be read directly through “IN” command, also,
Summary of Contents for ZMC006CE
Page 1: ......
