ZMC308BE Motion Controller Hardware Manual V1.5
(5)
Correctly set the relevant parameters of the third-party equipment according to their
respective instructions to match the parameters of each node.
(6)
Correctly set the "address" and "speed" of the slave expansion module according to
the manual of the slave.
(7)
After all the settings are completed, restart the power supply of all stations to
establish communication.
(8)
Note that the "speed" settings of each node on the CAN bus must be consistent, and
the "address" settings cannot cause conflicts, otherwise the "ALM" alarm light will be
on, and the communication establishment will fail or the communication will be
disordered.
3.3.
RS232 Serial Port
RS232 is in a standard DB9 socket and supports MODBUS_RTU protocol and custom
communication.
→
Interface Definition:
Terminal
PIN
Name
Type
Function
1
、
4
、
6
、
7
、
8
NC
Hang in
the air
Reserved
Summary of Contents for ZMC308BE
Page 1: ......
