ZMC308BE Motion Controller Hardware Manual V1.5
→
Wiring Reference
→
Wiring Note:
⚫
For the common terminal, please select the "EGND" port on the power supply terminal
to connect to the "COM" terminal of the external input device. If the power supply of
the signal area of the external device and the power supply of the controller are in the
same power supply system, this connection can also be omitted.
3.4.2.
Basic Usage
(1)
Please follow the above wiring instructions for correct wiring.
(2)
After power on, please use any of the three interfaces ETHERNET, RS232 and RS485
to connect to ZDevelop.
(3)
State values of relative inputs can be read directly through “IN” command, also, it can
be read through “ZDevelop/View/In”. Please refer to “ZBasic” for details.
(4)
Latch function can be set and opened through “REGIST” instruction, in software, use
Summary of Contents for ZMC308BE
Page 1: ......
