ZMC408SCAN Motion Controller Hardware Manual V1.5
Note:
➢
5
V power supply only supplies for handwheel, don’t supply power for others.
➢
All signals of this interface are digital input signals, number is IN (32-43).
3.10.1.
MPG Handwheel Interface Specification & Wiring
→
Specification
Item
IN (32-43)
Mode (input)
NPN leakage it is triggered when low electric inputs.
Frequency (input)
<5kHz is recommended
Impedance (input)
510Ω
Max voltage (input)
24V
The current to open (input)
<2.8
The current to close (input)
>2.9A
Min current (input)
-1.8mA
Max current (input)
-5.5mA
Isolation
optoelectronic isolation
5V power supply (H-5V,
EGND) max output current
100mA
→
Wiring Reference
