ZMC408SCAN Motion Controller Hardware Manual V1.5
→
Wiring Notes
Above is the example of UW-075, also, you can refer this to customize the specific
pin to be connected.
Please use the cable with shield, and shield layer should be connected to the ground
fully (chassis).
The YAG laser uses the EXIO extended IO interface and matches with (connects to) the
YAG adapter board to control. The laser control reference steps are as follows:
1.
Laser type setting: call the command EXIO_DIR(0, $FCBFE) to set the EXIO laser type
to YAG type.
2.
Laser work state setting: call the command MOVE_OP to operate OUT53 and set laser
to external control mode. Call the command MOVE_OP to operate SCH-1-SCH-
16’s
corresponding output to select work state mode.
3.
Turn on the laser: call the command MOVE_OP to operate OUT53 and set laser to
external control mode, and call the command MOVE_OP to operate OUT43 to turn on the
main shutter and corresponding branch shutter OUT, call MOVE_OP to operate OUT9 to
control output the light.
Note: for terminal control, please refer to laser manual description.
