ZMC408SCAN Motion Controller Hardware Manual V1.5
→
Wiring Notes:
⚫
The wiring of RS232 (port0) is as above, it needs to cross-wiring for sending and
receiving signals, and it is recommended to use a double-female head cross line
when connecting to a computer.
⚫
The wiring of RS485 (port1) is above, it is the daisy chain topology is used for wiring
(the star topology structure cannot be used). When the use environment is ideal and
there are no many nodes, the branch structure also can be used.
⚫
Please be sure to connect the public ends of each communication node to prevent
the communication chip from burning out.
⚫
Please use STP, especially in bad environments, and make sure the shielding layer is
fully grounded.
→
Cable Requirements:
Shielded Twisted Pair, and the shielded cable is grounded.
3.5.2.
Basic Usage
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please use any one interface among the three interfaces ETHERNET,
RS232 (there is default parameter, which can be connected directly) and RS485 (there
is default parameter, which can be connected directly, but for hardware, adapter head
is needed) to connect to ZDevelop.
