ZMC420SCAN Motion Controller
32
The controller has been
working normally, sending
out pulses normally, but
the motor does not rotate.
Check whether the connection between the drive and
the motor is correct, the drive and the controller
Whether the wiring between them is in good
contact.
Make sure that the drive is working properly and
there are no alarms.
The motor can rotate, but
the work is not correct
Check whether the set deceleration and speed exceed
the equipment limit;
often.
Check whether the output pulse frequency exceeds
the receiving limit of the driver;
Check whether the controller and the driver are
properly grounded, and whether the anti-interference
measures are done well;
The current-limiting resistor used in the
photoelectric isolation circuit of the pulse and
direction signal output
