●
Modules must not be fitted as overhead glazing. Ensure that the mounting system can also
withstand the anticipated wind and snow loads.
●
Precipitate can run off through small openings on the back side of the module. Make sure that the
openings are not masked after mounting.
●
The modules have passed mechanical load test 5400Pa,To avoid exceeding the maximum load,
site-specific live loads such as wind and snow should be taken into account.
●
The installation of project must be facing north in the southern hemisphere, and facing south in
the northern hemisphere, the electricity will be comparatively lower when the project facing west
or east. The incorrect installation will lead to the loss of power
●
The modules, which are connected in series, must be in the same angle, otherwise, it will lose
power because of the difference in sunlight intensity. Solar modules generate the power to the
maximum when they are pointed directly at the sun. For installations where the solar modules are
mounted to a permanent structure, the solar modules should be tilted for optimum winter
performance. As a rule, if the system power output is adequate in the winter, it will be
satisfactory during the rest of the year. The module tilt angle is measured between the solar
modules and the ground.
RECOMMENDED TILT ANGLES FOR A FIXED SYSTEM
SITE LATITUDE IN DEGREES
FIXED TILT ANGLE
0
o
TO 15
o
15
o
15
o
TO 25
o
SAME AS LATITUDE
25
o
TO 30
o
L5
o
30
o
TO35
o
L10
o
35
o
TO 40
o
L15
o
40
o
+
L20
o
