11
7.
Module wiring
Each module is provided with two standard 90℃ lighter Diameter of 4mm2,each of which
is connected with the plug and mobile connector. This cable can be used in the condition of line
exposed to direct sunlight. Our company recommends that all wiring and electrical connections
shall comply with the relevant national electrical codes.
For the field connections, please use the copper wire with a diameter not less than4mm2
and sunlight resistance not less than 90℃.
The outside diameter of cable should range from 5mm to 7mm. See the specification part
for the maximum electrical rated parameters of serial fuse.
8.
Tilt angle of module
ZNSHINE SOLAR AUSTRALIA PTY LTD. PV modules connected in serial should be
installed in accordance with the same orientation and angle. Any different orientations or angles
may result in the different amounts of solar radiation received by each module, thus leading to
the loss of output power.
The maximum power generation efficiency can be achieved when ZNSHINE SOLAR
AUSTRALIA PTY LTD. PV modules orientate right angle towards the sunlight. If it is
required to install the PV modules on a permanent structure, the tilt angle shall be adjusted
to the optimum winter use. The tilt angle of module should be determined according to the
situation between the solar module and ground. The optimum tilt angle of PV module is the
same as latitude of installation position in most cases.
9.
Mechanical drawing of module
Mechanical drawing of clamped module
