Manual Zocon Z300 Seed drill
2. TECHNICAL NOTICE
•
Chassis epoxy painting
•
Dimensions 670 large x 1000 long x 800 high, weight 60kgs (300 Liter)
•
The blower works with an electric 12 volts motor
•
The rotor rolls by an electric motor, five sorts of rotor exist
- White: slug pellet, insecticide (very small flow)
- Green: rape, alfalfa, clover, mustard, luzern (small flow)
- Yellow/stainless: phacelia, radish, mixing seeds (medium flow)
- Red: rye grass, corn (big flow)
- Black: cereals (very big flow)
•
An electronic control box is included with three switches:
- To start or stop the blower
- To start or stop the rotor
- A handling button with a 0 to 30 graduated scale for the flow, set directly in cabin
•
And a green light for working
•
The blower blasts the seeds through the flexible pipes of 30 mm
•
Two Motors: 12 volts
•
Blower motor: 140 watts
•
Rotor motor: 100 watts
3. FITTING
•
Fit the Z300 on the tool chassis, it should be placed on the stubble middle
•
Check the solidity of your installation. Position the machine so that there is no danger
for the operator being injured while it is being filled
•
When fitting the machine on the tool it is essential to install a guard rail
•
Install a platform with a handrail and access stairs to allow the hopper to be filled in
complete safety
•
Use perforated anti-slip metal
•
The spreader plates should be fitted so that the seeds fall just behind the
ploughshare of the stubble or the discs and before the roll between 30 and 70cm.The
spreader plates spread the seeds at a distance between 50 to 1.40m. Small
seedsshould be covered by the roll of the stubble. It is necessary to have a slope
down for the hoses and avoid reverse slope
•
Before working, check that the machine is not electronically connected
