How to Add Salt to the Pool
1.
Turn on pump to circulate pool water.
2.
IMPORTANT - Turn the power pack off by
pressing and holding the ON/Off button for 6
seconds.
3.
Test the water for salinity level using test strips,
electronic meter, or by your local pool
professional.
4.
Use the Table 1 to determine the amount of salt
to add. Be conservative when adding salt as it
is easier to add more if needed than it is to
dilute if there is too much salt.
5.
Disperse salt into pool. Do not add through
skimmer, main drain, or surge tank. Brush the
salt around the pool to facilitate dissolving.
Circulate filter system for 24 hours to
ensure even distribution.
6.
After 48-72 hours, verify correct salt reading by
testing the water salinity level using test strips,
electronic meter, or by your local pool
professional.
7.
When the salinity level is correct, turn the power
pack on. Press the buttons to set the desired
production rate.