INSTALLATION AND OPERATION MANUAL
WARNING
Operating Jandy TruClear® XL models without water flow through the cell can cause a buildup
of flammable gases which can result in FIRE OR EXPLOSION. READ THE LABEL AND
OPERATION MANUAL BEFORE USING. KEEP OUT OF REACH OF CHILDREN.
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is
licensed and qualified in pool equipment by the jurisdiction in which the product will be
installed where such state/ provincial or local requirements exist. The maintainer must be a
professional with sufficient experience in pool equipment installation and maintenance so that all
of the instructions in this manual can be followed exactly. Before installing this product, read and
follow all warning notices and instructions that accompany this product. Failure to follow warning
notices and instructions may result in property damage, personal injury, or death. Improper
installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can cause
serious injury, property damage, or death.
ATTENTION INSTALLER - This manual contains important information about the installation,
operation and safe use of this product. This information should be given to the owner/operator of
this equipment.
Maximum Overcurrent Protection – 15A
Use Copper Conductors Only
Disconnect Power before Opening Service Cover
For Outdoor or Indoor Use
Electrical Requirements: 120/240 VAC 50/60 Hz 3 WIRE, 4/2 AMP
Minimum salt level is 3000 parts per million
Controls bacteria and algae in swimming pool water
Do not use this device with bromide products
Notice to User
This pest control product is to be used only in accordance with the directions on the
label. It is an offense under the Pest Control Products Act to use this product in a way
that is inconsistent with the directions on the label.
