13
4.2.
User alerts
The status indicator on the control box flashes to alert the user. Follow the recommended troubleshooting tips below.
LED (Start)
Solutions
•
Disconnect and reconnect the cleaner.
•
Check that the cable is properly connected to the control box.
•
Check that nothing is interfering with the cable connection area.
•
If this fails to solve the problem, contact your retailer for a full diagnosis.
•
Check that debris or the cable is not preventing the brush or the tracks
from rotating freely.
•
Check that nothing is interfering with the cable connection area.
•
Rotate each wheel by a quarter of a turn in the same direction until it
rotates smoothly
•
If this fails to solve the problem, contact your retailer for a full diagnosis.
•
Turn the cleaner off.
•
Clean the filter thoroughly.
•
Put it back in the water, shaking to release the air bubbles.
•
Restart the cycle.
•
If this fails to solve the problem, please contact your retailer for a full
diagnosis.
•
Check that no debris or hair is blocking the impeller.
•
Clean the filter thoroughly.
•
If this fails to solve the problem, contact your retailer for a full diagnosis.
If the problem persists, contact your retailer:
Deleting an error code
•
After following the troubleshooting solutions, press a key on the control box to delete the error code.
EN
Summary of Contents for AquaSphere ASR 105
Page 2: ......
