9
Technical specifications
Admissible room temperature
°C 0-55
Admissible humidity level
%
0-90
Voltage
V AC
12
Maximum voltage
V AC
24
Protection index
IP 20
Dimensions: width / height / depth
mm
120 x 70 x 28
Hysteresis
Humidity
% 4
temperature
°C 1
Display
Hygro Control display
Hygro-thermostat
Hygrostat
Thermostat
On standby
Active
By default: display of the temperature and/or desired relative humidity.
Display of the ambient temperature and/or humidity by pressing
once,
°C
and/or
%RH
blink. To exit, press
, or wait 10 seconds.
*Only if your appliance is fitted with the hot water battery option, or extra electric
heating.
- The
numbering
of the terminals must be respected,
-
Do not put these cables into the same duct as other 230 V or 400 V to avoid any
risk of interference of the signals,
-
Obstruct
the place where the cable emerges from the wall or seal it by using materials
other than
silicone and silicone-based materials,
in order to avoid any arrival of air
exterior to the room through the duct or dividing wall.
Mains supply 12Vac-50Hz- between terminals 4 and 5.
Cable 5 x 1 mm²,
maximum length: 30
meters
“on/off”
General CAE terminals
Temperature* and humidity programming
or hygro-thermostat settings
Value settings
Temperature display*
Relative Humidity
Degrees fahrenheit
Degrees Celsius
Requesting
dehumidification
Requesting heating
Summary of Contents for CAE
