4
2.2 Dimensions
L : Width
660 mm
H
:
Height
720 mm
P : Depth
295 mm
3. INSTALLATION
The unit can either be located on the floor or be hung on the wall.
Standing on the floor :
The unit is equipped with 4 plastic legs. Make sure that all legs are supported by the floor and that the unit is not in contact
with the wall to avoid vibrations.
Hanging on the wall :
The unit can be hung on 2 screws inserted in the wall. In the attached bag please find 2 screws and 2 plastic wall inserts
suitable for those screws.
Both screws shall be horizontally located on the wall with a distance of 450 mm between them. On the metal rear panel of the
unit there are 2 pear like slots in which the heads of screws should be inserted.
In order to eliminate vibrations and noise, the 2 rubber supports in the attached bag shall be fixed to the lower corner of the
unit’s rear panel. Peel off the cover from the self adhesive strip attached to the rubber support and stick the supports to the rear
panel.
Caution :
When positioning the dehumidifier, ensure that it is placed on a level surface.
The dehumidifier shall not be installed at less than 60 cm from ceiling.
*
Important: positioning the dehumidifier shall comply with electric standards in force in the country.
4. CONNECTIONS
4.1 Electric connections
• The DT 850 dehumidifier shall be connected to main supply and be earthed in compliance with electric standards in
force.
• Section of cable : at least 3 x 1.5 mm².
• Electric protection : Differential circuit breaker 30 mA (not provided).
Caution:
•
Before connection, check that voltage and power input are in compliance with rating plate.
•
The DT 850 is safe. However, as other electrical appliances, use it with care.
•
Keep out of reach of children.
•
Do not clean by spraying or immersing into water.
•
Do not insert any object into the openings.
•
Disconnect from mains before cleaning the units or its components.
•
Never connect to an electrical outlet using an extension cord. If an outlet is not available, one should be installed by a
licensed electrician.
•
Any service other than regular cleaning or filter replacement should be performed by an authorized service representative.
Failure to do so could result in a loss of guarantee.
•
Never operate this appliance if it has a damaged cord or plug. If the supply cord is damaged, it must be replaced by an
approved service representative or a similar qualified person in order to avoid any hazards.
