Start / Stop Cleaning
The factory default cleaning mode is Floor/Walls/
Waterline.
Use
to change cleaning surface setting.
Toggle between modes:
Floor Only
(1h 15 min) Floor only
Floor/Walls/Waterline
(2h 30 min)
Floor, walls, waterline
With the cleaner submerged in the water,
press
to begin operation.
Press again to interrupt and cancel an in-progress
cleaning cycle.
NOTE
: The Control Unit automatically goes into standby
mode after 5 minutes and the display screen turns
off. Press any key to exit standby mode and view
remaining cycle time. Cleaner will continue to
function in standby mode.
Lift System
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be
activated at any time during or after a cleaning
cycle.
1. Press
on the Control Unit or
from the App (connected models) to begin
the automated procedure to bring the
cleaner to the wall.
NOTE
: To stop the procedure at any time, press and
release the button again.
2. Next, Press and HOLD
to rotate the
cleaner.
3. Once the cleaner is facing the wall of your
choice for retrieval, release the button.
4. Cleaner will drive forward and up the wall
it is facing. It will wait at the waterline to be
retrieved.
5. When in reach, remove the cleaner from
the pool using the handle. The cleaner
will quickly expel water to allow for lighter,
easier removal.
NOTE
: Never lift the cleaner out of the pool by the floating
cable.
Figure 14. Always remove cleaner using the handle
Page
12
Zodiac
®
Duo-X
™
Robotic Pool Cleaners
|
Owner's Manual
