background image

ELECTRICAL HAZARD

• Severe shock or injury will likely occur as a result of a drill or drill cord coming in contact with water. Never

allow electric drill or drill cord to come in contact with water. Only plug drill into a Class A (5 Milliampere

Trip) protected Ground Fault Circuit Interrupter (GFCI) in accordance with the National Electrical Code

Section 680. Please see your drill owner’s manual for further safety precautions.

EQUIPMENT UNDER PRESSURE

• Always turn pump off prior to installing or changing Nature2 cartridge. Your pump/filter system is operated

under pressure and the pressure must be released before you begin work. Please see your pump/filter

owner’s manual for further instructions.

PREVENT CHILD DROWNING 

• Do not let anyone, especially small children, sit, step, lean or climb on any equipment installed as part of

your pool’s operational system. Locate the components of your operational system at least 3 feet from the

pool so children cannot use the equipment to access the pool and be injured or drown. 

ATTENTION

Failure to heed the following warnings can result in

permanent injury, electrocution or drowning.

!

Safety Instructions

Important Information

Please read prior to installation

The Nature2 Pool Sanitizer is designed for residential swimming pools only.

Installation and Operating Manual

FOR INGROUND POOLS AND ABOVEGROUND POOLS

IMPORTANT

Pool Owner, save this manual! 
Builders, leave this manual with the pool owner!

Thank you for purchasing a Nature2 Express pool sanitizer. Please take a moment to read through the entire manual

before installing your Nature2 Express.

Nature2 Express has been designed to sanitize inground and aboveground swimming pools of up to 25,000 gallons.

If your pool is larger than 25,000 gallons do not install this unit, but ask your pool professional about a Nature2 “G”

or “A” model vessel system.

Summary of Contents for Nature 2 Express









Reviews: