18
H0491600.C - EN- 2015-12
5.2 I User alerts
User alerts (depending on the model)
Soluti ons
Flashing LED:
Error code:
Er: 10
• Check that the cleaner is correctly connected to the
control box. If necessary, unplug it and reconnect it
following the appropriate procedure.
Er: 02
Er: 03
Er: 05
Er: 06
• Check that there is nothing preventi ng the brushes
and wheels from turning. To do so, turn the wheels
(1/4 turn) to release any debris that may be jammed.
Er: 07
Er: 08
• Cleaner operati ng outside the pool. Make sure you
start the cleaner when it is in the water (see § “3.3
Immersing the cleaner”).
Er: 01
Er: 04
• Check that there are no stones or hair in the propeller.
• Clean or change the fi lter if necessary.
5.2.1 Error codes
• Pressing a key deletes the error code and turns off the control box.
• The screen switches to standby aft er 10 minutes. To turn the screen back on, just press any key.
• When an error is detected, the control box temporarily suspends the programme (the
LED is turned off ).
• Press and hold the
key to revalidate the current programming.
5.3 I Pre-diagnosti c menu (depending on the model)
• Stopping the device if a cleaning cycle is in progress.
• To access the menu:
OV 3500 - OV 3510 - RV 4550 -
Vortex
TM
4 PLUS
Press
for at least 5 seconds.
RV 4560 - RV 5400 - RV 5470 - RV 5500 - RV 5600
Press
+
for at least 5 seconds
• The device status informati on scrolls:
3 seconds
The total operati ng ti me (in hours)
3 seconds
The last error code (if the cleaner has had at least one error)
3 seconds
Back to menu
The operati ng ti me during the error (if the cleaner has had at least one error)
Tip: if you require assistance, inform the reseller about the device's conditi on
EN
