8
H0491600.C - EN- 2015-12
3.4 I Electricity supply connecti ons
• Use of an electrical extension is prohibited when connecti ng the control box.
• Make sure that the socket can be easily accessed at all ti mes and is kept out of rain or splashes.
• The box is splash-proof but must not be immersed. It must not be installed in a fl oodable
area; keep it at least 3.5 metres away from the edge of the pool and avoid exposing it to direct
sunlight.
• Place the control box near the socket.
• Unscrew the protecti on cap (see image )
.
• Connect the fl oati ng cable to the control box and lock it into place by turning it clockwise (to avoid damaging the
fl oati ng cable) (see image , )
.
• Make sure that the connector is fully pushed in so that no water can get in (see image )
.
• Connect the supply cable
(see image ). Only connect the control box to a power outlet protected by a 30 mA max-
imum ground fault circuit breaker
(if in doubt contact a qualifi ed technician).
Tip: choose the locati on of the control box carefully to avoid the cable becoming entangled
Place the control box in the centre of the pool's length, following the safety conditi ons relati ng to electrical
connecti on. This lets you limit the length of the fl oati ng cable to be put into the water to cover the pool,
which reduces setup and storage operati ons.
EN
