Zodiac Sweepy M3, User Manual

18

b) Manual operation

In this mode your robot will move in the direction you indicate by using the control buttons on the control
box.

• Set the manual / automatic mode button on the control box to manual mode.

• Set the «I/O» rocker switch to «I» (Fig. 8).

• Press the «Start» button to start the appliance.

• To make the robot move forward or back use the 3 position switch «Forward, Stop, Back»

IMPORTANT : the robot will not move if this switch is in the central position (STOP).

• To change the direction of the robot, use the button controlling the rotation while the robot is moving

forward or back.

• You can change to automatic mode at any time by setting 

the switch to automatic mode. The robot will start performing 
the pre-set program as if it had been started up in automatic mode.

• After use, set the «I/O» switch to «O» and disconnect the supply lead from the mains.

IMPORTANT : Wait for about 1/4 hour before taking the robot out of the water.

3. Cleaning and Maintenance

Cleaning the filter bag
We advise you to clean the filter bag after completion of every cycle.

• Switch off the robot at the mains electricity supply and disconnect the control box from the mains.

• Take the robot out of the water using the lifting cord (Fig. 9) and put it upside down beside the pool

(Fig. 10), so as to access the filter holder plate located on the underside of the robot.

• Unlock the four hooks (Fig. 11) and pull out the 4 clips holding the plate. Remove it, holding it

upside down so that the debris stays in the bag (Fig. 12).

• Undo the 2 plastic locking clips (Fig. 13) to permit removal of the bag. Empty the bag and clean it

under running water or in slightly soapy water if necessary. If using soap, rinse thoroughly taking care
to turn it over. Do not wring to dry it, or put it in the washing machine.

• Also rinse the filter holder plate and remove any debris caught under the flaps.

• Replace the filter bag by positioning the seam over the short width of the filter holder and the

corners of the bag over the corners of the stainless steel rails (Fig. 14). Put back the plastic locking
clips

• Replace the filter holder, snap shut and lock using the hooks.