Zodiac WAVE 275 Aero, Owner'S Manual

4 / 12 

ASSEMBLY 

Choose a smooth and clean surface 

IF THE BUOYANCY TUBE WAS STORED AT A TEMPERATURE BELOW 

0°C / 32°F, LEAVE IT  AT 20°C / 68°F FOR 12 HOURS BEFORE 

UNFOLDING. 

310 COMPACT 

No assembly is required 

275  ROLL UP : 

Boat deflated, slide the slats in their pockets starting by the closest to the transom. If the slats are 
difficult to insert, lubricate it with liquid soap. 

275 AERO – 310 AERO :       INFLATE THE HIGHT PRESSURE FLOOR 

           HP INFLATABLE FLOOR DEFLATED 

•

•

efore inflating, open out the boat and position the keel on the central band of the bottom and on the 
floorboard axis (centered between the positioning pins). 

•

FIRST 

inflate the keel-floorboard assembly to its rated pressure.

•

Check that the keel inflated perpendicular to the floorboard and that it is still positioned on the 
central band of the bottom (otherwise, reposition).

•

Inflate the main buoyancy tube.

•

Press the floorboard down around the edges to fit it into the hollow of the angle. 

MAINTENANCE / DISMANTLE OF THE HP INFLATABLE FLOOR 

We recommend that you leave the H2P floor in the boat when folding. 
To clean perfectly the boat proceed as follow: 
 
Deflate the boat and the floor. 
Inflate again the boat a little. 
Wash off with clear water and then raise the boat’s nose to evacuate water and sand or rubbish. 
Do not separate the keel from the floor nor from the buttom.