COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
- 43 -
4. Press again to confirm the corresponding recovery operation, sewing lights off;
5. Press
to quit the setting mode of service parameters. Then the system will return to
the normal sewing mode;
6. And then, turn off the power and repower the machine after about one minute.
7. After the completion of the restoration,the corresponding systerm setting to restore the state
［
6
］
MAINTENANCE
1. Adjusting the height of the needle bar
Turn OFF the power before starting the work so as to prevent
accidents cause by abrupt start of the sewing machine.
0.8 to 1mm
F type only
system buzzer long sound prompts to restore success.
of the factory,the main control of the parameters
、
the panel P
、
C pattern
、
pattern number
XYscaling
、
Maximum speed will be restored to the default value.
Summary of Contents for ZJ1900DSS
