FTC014
FTC014
SINK W
ALL
W
ALL
Locate a hole centre in the countertop at
least 50mm from the wall and with enough
clearance to the rim/flange of the sink.
Dim. A >50mm(2”) and Dim. B >50mm (2”) .
If you need to locate the faucet within these
dimensions, you should ensure enough
clearance for the mounting washers and
nut (9,10,11). Cut a hole 26mm diameter
into the countertop .
Step 2
SINK W
ALL
W
ALL
A
B
SINK W
ALL
W
ALL
Insert the faucet into the countertop. Then
slide the washers (9 and 10) onto the threaded
tube (8) of the faucet followed by the nut (11)
in the order shown in the diagram. Tighten the
nut (11) with a wrench and ensure the faucet is
correctly aligned above the countertop.
Step 3
Tighten the converter (12) and filter
connector (14) with a wrench,
ensure
washer (13) is between the converter (12)
and
filter connector (14). Then connect filter
hose to the filter connector(14).
Step 4
Remove the Filter connector (14), disassemble
other parts in sequence (9) (10) (11) (12) (13).
Ensure threaded tube (8) is tight in the faucet
body (4).
Step 1
(1”)
