5
A
B
6
7
a
7
b
A. Swivel the cover
on the bottom of
the charging tower
to reveal the
ON/OFF
switch.
Slide to the
ON
po-
sition to turn on the
tower. Note the
Reset
button below
the
ON/OFF
switch.
B. Replace the cover by swiveling it and snapping into
place. To reset the charging tower at any time, press
the plus sign (
+
) on the cover until the
Reset
button is
depressed.
Note
the small bulge on the bottom of the charging
tower (shown in picture, above). This indicates the ap-
proximate location of the
Reset
button on the bottom of
the tower.
Bulge
Underside
surface of
table
To use the Powersol table (sold separately):
A. Slide the Powersol table up from the bottom of
the pole until flush with the bottom of the charging
tower.
B. Hand-tighten the two knobs on the bottom of
the Powersol table to secure it to the pole.
To use your own patio/picnic table with Powersol:
A. Insert the umbrella pole into the patio table. Slide the
bottom locking collar (sold separately) up from the bottom
of the pole until flush with the underside surface of the table.
B. Using the hex wrench, tighten the screw on the locking
collar until the collar is fastened tightly to the pole.
Note:
When using a base or pedestal, you can raise the
height of the umbrella by inserting one or more spacers
(see Parts List) into the base insert.
A
B
A
B
A
B
A. Slide the top locking cap down until it sits flush on
the top of the charging tower.
B. Using the hex wrench, tighten the three screws on
the locking cap until the cap is fastened tightly to the
pole.
