OPENING YOUR SAFE FOR THE FIRST TIME
On receipt of Safe, open the Safe with the mechanical override key
(emergency key)
• Remove the Key Hole Cover given on Operating panel
• Insert Mechanical Override Key (Emergency Key) & Turn it counter clock-wise
• Then Turn the knob clockwise to open the Safe door
CAUTION
:
One the Safe opens. remember to pull out the mechanical override
key (emergency key) and keep it in a secure place outside the Safe.
INSERTING THE BATTERIES
• Open the door
• Insert 4 x AA batteries into the battery compartment given on the backside of
the Safe door.
• Under normal condition, if both of the red & green light are turned on at the
same time, it means the voltage is low and you should insert new batteries
CAUTION
:
Replace 4 fresh batteries by lining them up in a manner as indicated
by “ + “ and “ - “ signs.
SETTING THE USER CODE
• With the Safe door open, press the reset button given inside of the Safe door.
• Enter your new user code (3-8 digits) and press “ ” or “ ” button to confirm.
Sound of a buzzer beep will indicate the acceptance and storage of the new
User Code.
• If the yellow beeps flashes along with 3 buzzer beeps, then it indicates that
code registration has been ineffective and you need to try again.
OPENING THE SAFE
• Enter your new User Code (3-8 digits). immediately one buzzer beep will occur
along with yellow light flash.
• Press “ ” or “ ” button and green light will turn on.
• Rotate the knob clockwise and the Safe door will open.
3
