ZVK-66 User Manual
Issue 03
Page 9 of 17
Z
V
K
-
6
6
Configuring using FusionEdit
It is possible to configure a ZVK-66 keyboard through the FusionEdit GUI. Click on the Setup menu option, located at the
top left of the screen, then select the keyboard config option.
When the settings are correct, press either the “Link Fusion to Keyboard” or “Link Keyboard to Fusion” button. If you do
not wish to save the settings on either piece of equipment, click on close.
•
Link Fusion to Keyboard
This will save the displayed settings to both the ZVK-66 and Fusion.
•
Link Keyboard to Fusion
This will change the MAC of the keyboard to match the MAC currently used by the Fusion workstation,
Joystick Calibration
The joystick is a fully proportional type and, as such may require re-calibrating from time to time.
1) Press the “Calibrate local keyboard” button.
2) All the LEDs except the PTZ LED will go out. The PTZ LED will start flashing on the ZVK-66.
3) Move the joystick around all the extremes of the axis (left, right, up, down, clockwise and anti clockwise)
4) Press the button on the joystick to finish. The keyboard will stop responding for a moment whilst the values
are saved
5) Automatically returns to the previous mode of operation.
This will open a new window that will display the MAC (machine access code)
address and termination setting once they have been selected by the keyboard.
To put the keyboard into calibration mode, press the
“Calibrate local keyboard” button. This will calibrate the
keyboard that is currently linked to the Fusion workstation.
The “Force MAC” button is used to force MAC and
termination settings onto a keyboard.
The
Keyboard Link
section will become active as soon as
the keyboard is put into configuration.
Note this configuration screen must be displayed before
putting the keyboard into configuration mode.
