1-PREPARATION STEPS
7
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251112-001093 M6×16 Hexagon flange bolts (color zinc)
1
12±1.5N.m
2
1251513-001019 6.3×12×1.6 copper gasket
1
PROCEDURE:
●
Put antifreeze
Place a container under the drain hole, ready to receive antifreeze, use an 8# sleeve to remove the bolt (1), and
remove the copper pad (2).
Locate the water filler cap at the lower link plate on the right side of the vehicle, press down the water filler cap
and turn it counterclockwise before removing it, and wait for the antifreeze to drain.
CAUTION:
●
Gasket
⑵
After disassembly, new gaskets must be replaced to avoid water leakage.
●
Antifreeze is corrosive to a certain extent, so be careful not to contaminate the engine, other parts, body,
clothing, etc., when discharging the antifreeze. If parts are accidentally contaminated with antifreeze,
immediately wipe them with a clean lint-free cloth. If clothing or skin is stained with antifreeze, immediately
rinse with clean water. If the antifreeze is splashed into the eyes, immediately rinse with plenty of water and
observe to decide whether to seek medical attention.
●
The engine can be removed from the vehicle after draining the antifreeze and engine oil.
Fig.3 PREPARATION
STEPS
Drain antifreeze
