33
NO
SE
FI
GB
DE
DK
PL
ET
Check that the cooling water hose is not
kinked or trapped.
Place the cooling water pump in place in
the water tank (shown as B in fi g. B8).
Preparation
Place the tile cutter on a fl at and stable
surface.
Remove the transport protection (13) (fi g.
B9).
Fill the water tank (2) with clean tap water
until it is around 5 mm below the edge of
the tank.
Insert the plug with the earth fault current
relay (22) into a power socket. The earth
fault current relay turns the machine off if
the earth fault current goes above 30 mA.
Testing the earth fault current relay
Press the TEST button for less than 1 second
on the earth fault current relay (fi g. B10).
The indicator light goes off .
Press the RESET button. The indicator light
comes on (shown as A in fi g. B10).
If the indicator light does not come on, wait
10 seconds and press the RESET button
again.
The tile cutter must not be used if the earth
fault current relay is not working properly!
Setting the cutting length
Set the end points for the cut using the
knobs (9) (shown as A and B in fi g. B12).
Summary of Contents for 66157
