22
56K Faxmodem Owner’s Manual
To set the faxmodem to COM 2 and test IRQs 12, 11,
7, and 5 in the Wizard mode, type:
portwiz 2f8 12 11 7 5 /w
and press Enter. Note there are no commas, but the
spaces are required.
4. If you type:
portwiz
and press Enter without typing any arguments,
PORTWIZ displays a list of instructions on the screen.
Setting Up Your Internal Faxmodem with
Jumpers
This section is not appropriate for Windows 95 users. MS-
DOS, Windows 3.1 or 3.11, and Windows NT users should
read the appropriate instructions below.
For MS-DOS Users
If you are replacing an existing modem, remove the old
one and check its jumpers for COM port and IRQ
settings. (See your computer’s documentation if you need
help opening your computer and removing boards.) Write
the settings down on the Important Information page in
the back of your Quick Start.
Proceed to page 46 in Appendix D. Set the jumpers using
the old modem’s COM port and IRQ, and return to In-
stalling an Internal Card in Your Computer on page 12.
If this is the first modem installed in your computer, use
the ZPORTS utility to suggest a COM port and IRQ:
Insert the COMit disk in your floppy drive.
From the DOS prompt, type A:\ (or the drive letter of the
correct drive) and press Enter.
Type:
zports
and press Enter.
1
2
3
