64
ZOOM B9.1ut
How to read the parameter table
Effect Types and Parameters
This is a delay module that allows use of the hold function. Effect parameters are described after the listing of
effect types.
Delay
This is a long delay with a maximum setting of 5000 ms.
PingPongDly (Ping Pong Delay)
This is a ping-pong type delay where the delay sound alternates between left and right.
This effect simulates an analog delay with a long delay time of up to 5000 ms.
The above
fi
ve effect types have the same parameters.
PARM1
PARM2
PARM3
PARM4
Time
1 – 5000ms
FeedBack
0 – 100
HiDamp
0 – 10
Mix
0 – 100
Sets the delay time.
Adjusts the feedback amount.
Adjusts the treble attenuation of the
delay sound.
Adjusts the balance between
original sound and effect sound.
ReverseDelay
This is a reverse delay with a long delay time of up to 2500 ms.
PARM1
PARM2
PARM3
PARM4
Time
10 – 2500ms
FeedBack
0 – 100
HiDamp
0 – 10
Balance
0 – 100
Sets the delay time.
Adjusts the amount of feedback.
Adjusts the treble attenuation of the
delay sound.
Adjusts the balance between
original sound and effect sound.
DELAY module
Tempo sync
The note symbol ( ) in the table indicates that the parameter can be synchronized to
the patch specific tempo. If you select the note symbol as a value for the parameter
when making the setting at the B9.1ut, the parameter value will be synchronized to
the patch specific tempo in note units (
→
p. 38).
Expression pedal
The pedal symbol ( ) in the table indicates that the parameter can be controlled
with the built-in expression pedal. If you select the parameter as control target when
making the setting at the B9.1ut (
→
p. 31), the expression pedal will adjust the
parameter in real time when the patch is selected. Parameters with the pedal symbol
can also be selected as control targets for the ARRM function.
Delay tap/hold delay/delay mute/hold synth
The , , , and indications in the table show that the
respective function foot switch 1 – 3 can be used to specify the delay time (TAP),
toggle hold delay on and off (HOLD), toggle delay mute input between on and off
(MUTE), and toggle hold synth on and off (SYNTH). These functions apply to the
DELAY module (TAP, HOLD, MUTE) or the PRE-AMP module (SYNTH).
To use these functions, the respective function must be assigned to the function foot
switch 1 – 3 (
→
p. 36) and the respective effect type must be enabled.
Effect parameters 1 – 4
Effect type
When this effect type is selected, the four parameters listed here
can be adjusted with parameter knobs 1
−
4. The setting range
for each parameter is also shown. Some effect parameters are
adjusted with the knobs of the pre-amp section.
Effect module
0804B9E.indb 1
0804B9E.indb 1
08.4.25 10:59:14 AM
08.4.25 10:59:14 AM
