Machine startup
Before plugging the machine into the power receptacle it’s very important to make sure the reel blade spins
freely each day. Please refer to page 8 and 9 of this manual then continue with this procedure.
Move the Zoom into position on a somewhat flat surface and adjust the jacks accordingly on each side with the
hand cranks to get the correct barrel slope and levelness from side to side for the hopper. This will anchor the
machine in place and allow you to set the speed of travel with the machine angle and barrel rotation speed
control. Refer to figure 1.9 below.
Figure 1.9
On/Off & Barrel Speed Control
Note:
Make sure the cord is a minimum of 12/3 AWG and less then 50ft in length.
Using 14/3, 16/3 or 18/3 cords
will void the warranty and damage the motors.
Do not overload electrical outlets. Failure to comply with electrical code could result in fire or electrical shock.
It’s best to have a dedicated circuit for the machine. Consult an electrical contractor for assistance.
Page 10