General Maintenance
Maintenance will depend on the amount of use the machine is operated. This will describe what you should do
if the machine is used on a daily bases.
Warning!!!
General maintenance should only be done when the machine power is disconnected with no exceptions.
Grease lubrication
The brush bearings with grease fitting should be greased once per year.
Adjustment
The cutting reel and each barrel should be check for damage each day and adjustments made as necessary
before cutting.
Note:
Operating the machine with damaged blades could result in further damage or personal injury. An
authorized technician or the manufacture must repair damage.
Cleaning
A thorough cleaning of the machine should be done on a daily basis. Material buildup can cause poor
performance, overheating and hard startup for later use. As the residue dries it will become hard and more
difficult to remove. Be extremely careful to avoid sliding your fingers along the blade lengthwise. Refer to the
cleaning section of this manual on pages 12 - 13.
Vacuum maintenance
Change or empty the bottom debris bag daily on the vacuum. Keeping the top bags clean for maximum airflow
will give you the best performance possible. Disconnect power before cleaning around impeller for heavily used
vacuums.
Page 14
