21
ZOOM UIB-01
UIB-01
Applications
This section describes the various uses of the UIB-01.
Project backup/restore
You can copy a project from the MRS-1044 recognized as a local disk to
the hard disk of the computer, for creating a backup. A backed-up project
can be restored to the MRS-1044 at any time.
Backing up a project
1.
Start up the MRS-1044 in USB mode and connect it to the
computer with a USB cable.
Verify that the online state is established.
2.
Open "My Computer" and double-click on the local disk
representing the MRS-1044.
The contents of the MRS-1044 hard disk are shown. Project data are
stored separately in folders named "PROJxxx" (where "xxx" is the
project number from 000 - 999).
Other folders and files are used by the system of the MRS-1044.
Take care not to accidentally delete these. For information on the
contents of the MRS-1044 hard disk, see p. 28.
20
ZOOM UIB-01
UIB-01 Applications
Preparations
The computer and MRS-1044 are now in the offline state, and you
can terminate the USB connection.
In the offline state, the "USB Storage Unplug" icon should
disappear from the task tray. If not, right-click on the icon and
select [End of USB Storage Unplug].
3.
Push the [POWER] switch of the MRS-1044.
The indication "PowrOFF ENT/EXIT" appears on the display of the
MRS-1044.
4.
Press the [ENTER] key of the MRS-1044.
Power to the MRS-1044 is turned off. When you turn the power on
again in this state, the unit starts up normally.
5.
If necessary, disconnect the USB cable.
This procedure must be followed every time you wish to terminate
the USB connection between the computer and the MRS-1044 to
turn the MRS-1044 off.
NOTE
