UIB-02 ONLINE MANUAL
9
When the computer and MRS series are in the online state, a program called “USB
Storage Unplug” will be added to the task tray on the Windows 98 desktop. Use this
program when wishing to terminate the USB connection between the MRS series and
the computer.
[HINT]
- The driver installation process must only be carried out once. After the driver is installed,
simply starting up the MRS series in the USB mode and connecting it to the USB port of the
computer will establish the online state.
- When wishing to uninstall (delete) the driver, use the “UNINST” program on the supplied CD-
ROM.
S E T T I N G T H E C O M P U T E R A N D M R S S E R I E S T O T H E
O F F L I N E S T A T E ( W I N D O W S 9 8 )
If you simply unplug the USB cable or turn power to the MRS series off while the
computer and MRS series are in the online state, computer operation may become
unstable, and serious damage to files may occur.
Always perform the steps listed below to terminate the USB connection between MRS
series and computer.
1.
Click on the “USB Storage Unplug” icon in the task tray, and select [ZOOM
ATA/ATAPI Bridge Mass Storage Controller...].
“USB Storage Unplug” is a program for setting the computer and MRS series to the
offline state. The icon for the program automatically appears in the task tray when the
online state is established.
When the PC and MRS series are in the offline state, a message appears indicating that
the hardware can be safely disconnected.
2.
Click on the [OK] button in the dialog box that appears.
The computer and MRS series are in the offline state, and you can terminate the USB
connection.
[HINT]
In the offline state, the “USB Storage Unplug” icon should disappear from the task tray. If not,
right-click on the icon and select [Stop USB Storage Unplug].
3.
Press the [POWER] switch of the MRS series and then press the [ENTER]
key.
Power to the MRS series is turned off. When you turn the power on again in this state,
the unit starts up normally.
