2B Installing the ZoomAir PC Card under Windows NT 4.0
22
2B
Installing the ZoomAir PC Card
under Windows NT 4.0
Installing your ZoomAir Wireless PC Card in a Windows NT
4.0 computer is a three-step process:
•
Insert the card
•
Install the drivers
•
Run the ZoomAir setup software.
Note:
If you are installing ZoomAir on a computer that has a
previous version of ZoomAir installed on it, or if you ever
need to uninstall the ZoomAir PC Card, go to Appendix
B for instructions on removing old drivers.
Inserting the ZoomAir Card
Note:
If you are installing ZoomAir with the ISA adapter card,
go to Appendix A now to install the adapter. Then return
to this chapter to complete the installation.
1
1
The computer should be turned off.
Write down the serial number of the card in the Important
Information table on page 64. Also write down the MAC
(Media Access Control) address on the bottom label. You may
not need this in an ad-hoc network, but it is a good idea to
have it recorded for future reference if you are installing an
infrastructure network. The number is different for every net-
work card and is its unique identifier.
2
2
Insert the ZoomAir Card into its slot, being careful that it goes
in straight. The label with the ZoomAir logo and the LED
indicators should be facing up. The card should slide in easily