3.2
Printed Circuit Board Viewed from Inside the Cabinet
4.0
Cabinet Installation
WARNING:
Please read this section completely before commencing installation.
Prior to commencing installation of the control panel, ensure that adequate precautions are
taken against static damage to the sensitive electronic components on the control board. You
should discharge any static electricity you may have accumulated by touching a convenient
earthed object, e.g. an unpainted copper radiator pipe. You should repeat the process at
regular intervals during the installation process, especially if you are required to walk over
carpets.
The panel must be powered down before removing or replacing any card or module. Failure to
observe this may cause damage to the loop cards and the motherboard.
When changing any plug-in cards or printers, observe anti-static precautions. Ensure that all
power is removed from the system. Failure to do so may result in damage to the cards or panel.
The panel must be located in a clean, dry position which is not subject to shock or vibration
and at least 2 metres away from pager systems or any other radio transmitting equipment. The
maximum temperature range is 0ºC - 40ºC; maximum humidity is 95%.
This equipment may contain dangerous voltages. To prevent electric shock to unqualified
personnel ensure that the door is locked at all times when the panel is left unattended. Do not
leave the key to open the panel door with unqualified personnel. There are no user-serviceable
parts inside.
B/+
A/-
SCN
B/+
A/-
SCN
FLT
24V
0V
PROC RESET
NODE ADDRESS
DIL SWITCH
EPROM WITH
SOFTWARE
REFERENCE
PRINTER
INTERFACE
ZONE BOARD DISABLE
MONITORING LINK
ZONE BOARD
INTERFACE
PROC FAILED
COMMS FAILED
CONNECT TO
PANEL
CONNECT TO
NEXT REPEATER
24V AND 0V
SUPPLY
DISPLAY
