2
Pump
Controller
Adapter
Power Cord
O Ring large / small
Name of each part
A Pump Cover
B Fixing Bolt
C Fixing Nut
D Impeller
E O Ring
F Pump Core
G Pump Mount
A
B
C
D
E
F
G
Drain Hose
Connector
Water Intake Parts
●Content
●Installation method in the water tank
1. Attach the large O-ring to the water inlet and the small O-ring to the drain, and then
attach the water inlet part and drain hose connector from above.
O Ring
Big
O Ring
Small
Make sure that the pump does not run idle due to a drop in the water level at the
pump installation location or water absorption location. Since it may cause a pump
failure or serious accident. The warranty is not cover in this case.
Install the adapter and controller in a place without heat or humidity.
Attention
Drain hose
connector
Water intake parts
Remove the main unit and all attached parts from the box and check that if there any
damage during transportation.In particular, make sure that the cord is not damaged.
If any damage is found, do not use it and contact your dealer.
