10
IONITX series Motherboard
+
.
.
.
120
240
121
120
240
121
1
.5
V
1
.5
V
DDR3_1
DDR3_2
Preparing the Motherboard
The motherboard shipped in the box does not contain a memory. You need to pur
-
chase these to complete this installation.
Installing Memory Modules
Your new motherboard has two 1.5 V 240-pin slots for DDR3 memory DIMMs. These
slots support 1 GB/2 GB/4 GB DDR3 technologies. There must be at least one memory
bank populated to ensure normal operation. Use the following the recommendations
for installing memory. (See Figure 1 for the location of the memory slots.)
q
One DIMM
: Install it into slot 1 or 2. You can install the DIMM into any slot, how
ever, slot 1 is preferred.
q
Two DIMMs
: Install them into slot 1 and slot 2.
Refer to the following procedure to install memory DIMMs into the slots on the moth-
erboard. Note that there is only one gap near the center of the DIMM slot. This slot
matches the slot on the memory DIMM to ensure the component is installed properly.
1. Unlock a DIMM slot by pressing the module clips outward.
2. Align the memory module to the DIMM slot, and insert the module vertically into
the DIMM slot. The plastic clips at both sides of the DIMM slot automatically lock
the DIMM into the connector.
Summary of Contents for IONITX-N series
