10
Note:
The remote control provided depends on the IPTV service provider. The
appearance of remote control shown is for reference only.
Notes:
• The remote control is powered by two AAA batteries. Insert two AAA
batteries into the remote control according to the polarity instruction
displayed on it.
• During the operation, point the front part of the remote control to the
infrared receiving area on the STB.
5.2 Key Customization
There are four TV learning keys on the STB remote control (Power, TV/AV,
VOL+, VOL-) . These four corresponding functions on TV remote control can be
operated on the STB remote control through customization. Users can perform
some operations for both TV and STB by only using the remote control of STB.
1. Press and hold SET key for about 3 seconds until the learning status indicator
turns into solid green, which signals the starting of the learning process.
2. Place the two remote controls.
3. Press the key to be learned on the TV remote control (for example, the Power
key), the learning status indicator changes from solid green to solid red. Then
press the target key on the STB remote control (for example, Power key), the
learning status indicator changes from solid red to solid green, which signals
that the learning process is successful.
4. Follow step 3 to learn other keys.
5. After completing the learning process, do not perform any operations until the
learning status indicator is off, which signals that the learning information is
stored successfully. Or press SET key to save the learning setting and quit the
learning mode.
