Zte E7+, Quick Start Manual

48 

FCC RF Exposure Information and Statement 

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. 

Device types: 

E7+

(FCC ID:

2ACYS-E7

) has also been tested against this 

SAR limit. The highest SAR value reported under this standard during product 

certification for use at the ear is 

0.78

7

W/kg and when properly worn on the body 

is 

0.7

7

W/kg. This device was tested for typical body-worn operations with the 

back of the handset kept 0

cm from the body. To maintain compliance with FCC 

RF exposure requirements, use accessories that maintain a 0

cm separation 

distance between the user's body and the back of the handset. The use of belt 

clips, holsters and similar accessories should not contain metallic components 

in its assembly. The use of accessories that do not satisfy these requirements 

may not comply with FCC RF exposure requirements, and should be avoided. 

This device complies with part 15 of the FCC rules. Operation is subject to the 

following two conditions: (1) this device may not cause harmful interference, 

and (2) this device must accept any interference received, including 

interference that may cause undesired operation. 

NOTE: The manufacturer is not responsible for any radio or TV interference 

caused by unauthorized modifications to this equipment. Such modifications 

could void the user’s authority to operate the equipment. 

NOTE: This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interference in 

a residential installation. This equipment generates uses and can radiate 

radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular 

installation. 

If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the 

following measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help.

 changes or modifications not expressly approved by the party responsible for 

compliance could

void the user's authority to operate the equipment