Zte MF928, User Manual

28

Radio Frequency (RF) Energy 

This model device meets the government’s requirements for exposure to 
radio waves. 
This device is designed and manufactured not to exceed the emission limits 
for exposure to radio frequency (RF) energy set by the Federal 
Communications Commission of the U.S. Government: 
The exposure standard for wireless devices employs a unit of measurement 
known as the Specific Absorption Rate, or SAR. The SAR limit set by the 
FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating 
positions accepted by the FCC with the device transmitting at its highest 
certified power level in all tested frequency bands. Although the SAR is 
determined at the highest certified power level, the actual SAR level of the 
device while operating can be well below the maximum value. This is 
because the device is designed to operate at multiple power levels so as to 
use only the position required to reach the network. In general, the closer 
you are to a wireless base station, the lower the power output. 
The highest SAR value for the model device as reported to the FCC when 
worn on the body, as described in this user guide, is 

1.251 W/kg.

While there may be differences between the SAR levels of various devices 
and at various positions, they all meet the government requirement. 
The FCC has granted an Equipment Authorization for this model device with 
all reported SAR levels evaluated as in compliance with the FCC RF 
exposure guidelines. SAR information on this model device is on file with the 
FCC and can be found under the Display Grant section of 
http://www.fcc.gov/oet/ea/fccid/ after searching on 

FCC ID: SRQ-MF928

. 

FCC Compliance 

This device complies with part 15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation. 
Caution: Changes or modifications not expressly approved by the 
manufacturer could void the user’s authority to operate the equipment. 
NOTE: This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses,