WF824 Getting Started
Confidential and Proprietary Information of ZTE CORPORATION 11
contact distributor to obtain replacement part.
My PC cannot acquire IP
from the CPE.
•
First check if the Network card is up and working properly. Then
check the PC Network card configuration and make sure the DHCP
is enabled.
•
To release and renew the correct IP address, please unplug the
Ethernet cable from PC and wait for about 5 seconds, then connect
it again.
•
If the problem persists, please contact the operator or distributor for
further diagnosis.
My CPE networking is not
working properly.
•
You may want to check if the wireless connection is up and
running properly. You can do this by login the WEB GUI and
check the Interface Info page.
•
You may want to perform a factory reset and see if the problem is
being corrected. You can do this by log into the WEB GUI using
“user” password and perform restore the unit to default factory
setting.
•
If the problem cannot be corrected by factory reset, please contact
the operator or distributor.
I forgot the login password
and like to reset the unit to
factory default.
•
User can also contact the operator.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
